I like lasers and wanted to get a laser on my P10C and wanted it to ether be or work just like the CT lasers and wanted it to be green.
So to start out, I bought a older CT green laser that was made for a gen4 glock 19. Did so with the intentions of deconstructing it, rebuilding it and putting it on my CZ P10C.
Was going to cut away the plastic that went around the trigger guard until it fit the P10C then rebuild what was needed with epoxy putty. Then make a cast of it then recast the entire CT housing using liquid urethane.
Well, turns out the Gen 4 glock trigger guard is closer in design to the P10C then I thought because I had the glock laser on the P10C in about 30 minutes.
Actually it only took about 10 minutes of file work with a large file and then a needle file. Lots of trial and test fitting.
More info and lots photos at the link below.
http://acmeholsters.com/misc/crimson-tracet-green-laser-for-cz-p10c/~