Forum Home

Archived material => For Questions covering both listed and less well known => Topic started by: Geobob on March 09, 2014, 04:57:26 PM

Title: RAMI Decocker Re-Install Problem
Post by: Geobob on March 09, 2014, 04:57:26 PM
Hello All


I have replacement firing pin assembly for my CZ RAMI BD coming from CGW and plan to disassemble and polish trigger parts at same time using a forum guide Dave from CGW sent me.  I removed the decocker lever(part #60 on CZ diagram)  to get a look at the sear cage, and upon re-inserting it, I notice the cam on the lever can't get by the front of the decocking lever arm (part #61 on the CZ diagram), leaving it about 1/16"-1/8" short of going in.  I can't find a way to rotate or move the decocking lever where that cam can clear its front.  The forum step-by-step guides I'm using don't say anything about reassembly methods, and I tried cocking the hammer, partially releasing, holding the trigger while hammer is back, etc. but can't find a way to move #61 fo the decocker level can be fully inserted.  Anyone have any experience with this?  Thanks in advance....
Title: Re: RAMI Decocker Re-Install Problem
Post by: Geobob on March 10, 2014, 01:34:54 PM
UPDATE:  Talked to Dave at Cajun Gun Works.  The trick on re-inserting the decocker lever post is to cock the hammer partway, then raise the back end of that pesky decocker arm (part #61) which lowers the front of it, and then the decocker lever post and cam will slip right in.  Just in case anyone else has a similar problem.  As I noted, CGW are really great folks and very willing to help if you need it.



Title: Re: RAMI Decocker Re-Install Problem
Post by: chfields on March 10, 2014, 01:40:37 PM
Great job on updating us!! Hopefully this will help others as well.... Again great job!!