Hello All
I have replacement firing pin assembly for my CZ RAMI BD coming from CGW and plan to disassemble and polish trigger parts at same time using a forum guide Dave from CGW sent me. I removed the decocker lever(part #60 on CZ diagram) to get a look at the sear cage, and upon re-inserting it, I notice the cam on the lever can't get by the front of the decocking lever arm (part #61 on the CZ diagram), leaving it about 1/16"-1/8" short of going in. I can't find a way to rotate or move the decocking lever where that cam can clear its front. The forum step-by-step guides I'm using don't say anything about reassembly methods, and I tried cocking the hammer, partially releasing, holding the trigger while hammer is back, etc. but can't find a way to move #61 fo the decocker level can be fully inserted. Anyone have any experience with this? Thanks in advance....