Forum Home
Archived material => For Questions covering both listed and less well known => Topic started by: GM4469 on January 08, 2012, 04:19:08 PM
-
Someone had asked me about sight installs.
Here is just a quick reference. Should work for any of the newer CZs that have the dovetail front sight ( vs the pre B tenon front sight )
Slide installed in vise
(http://i834.photobucket.com/albums/zz262/sdw1961/forum%20misc%20photos/_SDW2091.jpg)
drive out front sight pin
(http://i834.photobucket.com/albums/zz262/sdw1961/forum%20misc%20photos/_SDW2093.jpg)
drive out front sight
(http://i834.photobucket.com/albums/zz262/sdw1961/forum%20misc%20photos/_SDW2096.jpg)
Install new front sight and use drill to drill groove in bottom of sight for front sight pin
(http://i834.photobucket.com/albums/zz262/sdw1961/forum%20misc%20photos/_SDW2103.jpg)
Install front sight pin
(http://i834.photobucket.com/albums/zz262/sdw1961/forum%20misc%20photos/_SDW2105.jpg)
Loosen set screw and drive out rear sight
(http://i834.photobucket.com/albums/zz262/sdw1961/forum%20misc%20photos/_SDW2100.jpg)
Drive in new sight
(http://i834.photobucket.com/albums/zz262/sdw1961/forum%20misc%20photos/_SDW2107.jpg)
All done
(http://i834.photobucket.com/albums/zz262/sdw1961/forum%20misc%20photos/_SDW2110.jpg)
-
EXCELLENT! Thanks a lot GM! I'm sure this will help lots of people.
-
Thanks GM. That was really helpful. I got the rear tactical sight you recommended and put it on along with a fiber optic front sight. It went pretty much as you showed but I had to do a bit of filing to make them fit properly. I ended up scratching the new new sights a little but at least they're on!
-
Nice walk through. Thanks for the post. Now if I can get my hand to stop shaking long enough to hold the drill steady and straight................... :rolleyes:
-
Thanks you made that look pretty easy