Author Topic: Anybody else have a canted Scorpion receiver?  (Read 1345 times)

Offline Jon321

  • Newbie
  • *
  • Posts: 3
Anybody else have a canted Scorpion receiver?
« on: September 23, 2018, 10:49:46 PM »
Installing a aftermarket hand guard and the adapter block sits flush with the trunnion but you go to tighten the screws down and on one side and it raises and cants to the left and it throws my irons off.There is about a 3mm gap on one side of the rail and the other side is touching the receiver. My Scorpion  is going to be SBR'd  and is still processing  what if the receivers are out of spec how do you replace them when they are a  NFA item?   I never noticed this with the factory handguard only after taking the factory one off I noticed the cant
« Last Edit: September 23, 2018, 10:52:12 PM by Jon321 »

Offline Luger Fan

  • Jr. Member
  • **
  • Posts: 74
Re: Anybody else have a canted Scorpion receiver?
« Reply #1 on: September 24, 2018, 06:15:23 AM »
Once the series number is recut, making it a SBR, there is no changing anything.