Author Topic: Czechmate scope mount, can an RMR be milled on it?  (Read 1685 times)

Offline shootingisfun

  • Newbie
  • *
  • Posts: 24
Czechmate scope mount, can an RMR be milled on it?
« on: June 14, 2017, 06:54:14 PM »
So I want to put a RMR on my TS.  I have two choices for a frame mount, first the czcustom one which mounts to the left hand side of the frame and is secured by three screws and two steel pins.  The mount is already milled to receive the RMR I would just have to have my frame drilled and threaded.


The second option is to purchase the Czechmate red dot mount and have it milled for an RMR.  The czechmate mount is secured by three screws on each side of the frame and no pins.  This to me seems more secure.  I would have to have the mount milled to accept the RMR and then remove any excess material.  My question is, is there enough material in the center of the mount to mill it for an RMR? 


Thanks